Using Studio for Mac? It saves by itself a few seconds after each change and waits for the pad to confirm before it quits, so this rarely applies. If changes there aren’t sticking, see Studio for Mac problems.
Step 1 — Did you save?
Clicking Assign sends the change to the device and makes it active right away, but it does not write the change to flash memory. To make changes permanent, you must also click the Save button (the floppy disk icon) before disconnecting. If the Save button is not visible, your changes were already written — or there were no pending changes to save.Step 2 — Was the device still connected when you saved?
If you disconnected the MinimalPad before clicking Save, the pending changes were held only in memory and are now lost. You will need to reconnect and reapply the changes.Step 3 — Reconnect and retry
1
Connect MinimalPad
Plug in your MinimalPad and open https://studio.minimalmacropad.com/. Connect using USB or Bluetooth. See the USB connection guide if needed.
2
Reapply your key changes
Navigate to the key or layer you want to configure and make your assignments again.
3
Click Assign for each change
For each key you modify, confirm the change by clicking Assign. The key should update immediately on the device.
4
Click Save before disconnecting
Once all changes are assigned, click the Save button (floppy disk icon) to write everything to flash. Do not disconnect until the save confirmation appears.
Step 4 — Verify the save completed
After saving, the Save button should disappear and a checkmark or confirmation indicator should appear, showing that all changes have been written to flash. Only disconnect after you see this confirmation.If changes keep reverting even after you save correctly, flash the
minimalpad_with_studio firmware again. Flashing doesn’t erase the changes the pad has already saved, so check your keys afterwards. See Update the firmware.